Stainless Steel Solar Simulator Xenon Lamp Sunlight Simulation
Chamber
Application:
Full-spectrum solar simulator can be used to evaluate equipment
capacity exposure to the sun radiation under solar radiation heat or photochemical in hot season.The solar simulator can be used to evaluate the ability of equipment directly exposed to solar radiation in hot season to withstand the thermal effect or photochemical effect produced by solar radiation.The solar simulator can test the heat dissipation test samples and non-heat dissipation test samples. For the test of heat dissipation test sample, the heat dissipation power can not exceed the cooling capacity of the refrigeration system of the solar simulator, because the control of temperature and humidity is a dynamic balance process, in different temperature and humidity points, the cooling capacity of the refrigeration system is also accompanied by changes.
Specifications:
| The Temperature Test: | Temperature And Climatic Test: | Solar Radiation Test: |
| No radiation temperature range: -40℃～＋120℃ | Temperature range:＋20℃～＋85℃ | UV Exposure Area: ＞5600cm² |
| Radiation temperature range: -20℃～+100℃ | Humidity range: 10%RH～98%RH | The light wavelength: All band spectrum, simulated sunlight from 280 nm to 3000 nm |
Temperature uniformity: ≤1.5℃
| Temperature uniformity: ≤1.5℃
| Irradiation intensity : (0 ~ 1200) W/M² can be adjusted, and can be recorded continuously
during the test |
| Temperature deviation: ±2.0℃ | Humidity uniformity: 3.0%RH | N/A |
| Temperature fluctuation: ±0.5℃ | Temperature deviation: ±2.0℃ | N/A |
| Heating rate: ≥5℃/min | Humidity deviation: ＋2/－3%RH | N/A |
| Cooling Rate: ≥2℃/min | Temperature fluctuation: ±0.5℃ | N/A |
| N/A | Humidity fluctuation: ±2.0%RH | N/A |
Performance Curve Diagram:
Temperature And Humidity Curve Diagram
- Temperature range:＋20℃～＋85℃
- Humidity range:10%RH～98%RH
- Temperature uniformity: ≤1.5℃
- Humidity uniformity: 3.0%RH
- Temperature deviation: ±2.0℃
- Humidity deviation: ＋2/－3%RH
- Temperature fluctuation: ±0.5℃
- Humidity fluctuation: ±2.0%RH
Standards:
GJB150.7-86 Solar radiation test
GJB150A.7-2009 Solar radiation test
IEC60068-2-5 Test SA: Surface solar radiation simulation
GB2423.24 Test SA: Simulate solar radiation on the ground
DIN75220 Changes of automobile components in a sunlight simulator
MIL-STD 810G Environmental engineering related matters and
laboratory testing
Temperature, Radiation Diagram:
GB/T2423.24-1995 test procedure:
Take 24h as a cycle, irradiate for 8h, stop for 16h, repeat the
test as required (the total radiation amount of each cycle is
8.96kw.h /㎡, equivalent to the most severe natural conditions).
Take 24h as a cycle, irradiation for 20h, stop for 4h, repeat the
test as required (the total radiation amount of each cycle is
22.4kw.h /㎡).
Do continuous exposure as required.
