LDX-028A New servo feed alloy saw blade double grinding head side
grinding machine
In order to better use the alloy head saw blade grinding machine,
to achieve the use of saving worry and effort, if your grinding
machine tooth extraction abnormal phenomenon, then can not be
pulled at will, or can not go back up after pulling.
1,Solenoid valve failure, clean the solenoid valve.
2,The tooth extraction proximity switch is not bright, so that the
tooth extraction signal cannot be detected after it is pulled out,
and the rod cannot be pulled out. Open the outer cover of the tooth
assembly, check the position of the proximity switch, and adjust it
again.
3,Throttle valve failure, adjust or replace.
Classification of multi-blade saw gear grinding machine shaving
process:
1,When the gear grinding machine is shaving the teeth diagonally,
the drum shape that may occur in the direction of the teeth is
realized by the swing of the table around the center.
2,As we all know, radial shaving takes less time than tangential
shaving, but the machining surface is rougher. The solution is to
remove a large margin by radial cutting and then finish by axial or
diagonal shaving.
3,Different tooth direction correction can be obtained by using
discontinuous diagonal shaving cycle and double shaving process.
| Technical parameters: |
| Saw web machining diameter range:￠100-￠800mm |
| Saw web bore diameter: 12-220mm |
| Thickness of saw web (steel plate):1-10mm |
| Tooth pitch: 5-80mm |
| Front inclination angle, inclination angle: 5°-15° |
| Radial angle: 3°-15° |
| Operating speed: 18 teeth/min |
| Feeding stroke: 1-28mm (stepless variable speed) |
| Grinding wheel dimensions: 80*100*32mm |
| Grinding speed: 26m/s |
| Coolant pump flux: 501/min |
| Coolant cylinder volume: 90L |
| Total power: 4.3KW |
| Voltage: Three-phase 380v |
| Weight: 1,100KG |
| Outer diameter dimensions: 1.75*1.4*2.0mm |
| Technical characteristics: |
An intuitive and simple whole Chinese operation interface is
matched with a large-sized touch screen, so the equipment is easier
to operate, and all preset procedures or self-compiled procedures
are more convenient to call; the servo tool setting device features
accurate positioning, so the product grinding accuracy is greatly
ensured. Due to the adoption of high-quality and high-accuracy
castings and machined parts, the service life of the equipment is
greatly prolonged, and the equipment is simple and easy to operate
and maintain; one person can operate many pieces of equipment at
the same time, so the production efficiency is greatly improved,
and the cost is reduced.
|
