Metal Deburring Machine
General
To properly clean your belt disc edger and ensure its optimal
operation and longevity, follow these guidelines:
Turn off the machine: Before starting the cleaning process, ensure
that the disc edger is turned off and disconnected from the power
source for safety.
Remove residue: Use a brush or air pressure device to gently remove
any large particles of residue, such as metal shavings or dust,
from the machine's surfaces and individual components. If
necessary, utilize a vacuum cleaner or air pressure device to
collect loose residue.
Cleaning fluid: Select a suitable cleaning fluid based on the
material being processed, such as deionized water, detergent, or a
specialized metal cleaner. Refer to the manufacturer's
recommendations and instructions for the correct detergent and
concentration to use.
Avoid damage: Take care to prevent cleaning fluid or water from
directly entering the machine's interior or coming into contact
with electrical components. Instead, dampen a cloth or use a
sprayer to apply the cleaning liquid onto the cloth, and gently
wipe the surfaces and parts of the machine.
Drying and lubrication: After cleaning, thoroughly dry the
machine's surfaces and components using a clean cloth or paper
towel. For parts that require lubrication, apply an appropriate
lubricant as recommended by the manufacturer.
Safety guards and safety devices: Clean and inspect the machine's
safety guards and safety devices to ensure they are free from dirt,
damage, and properly installed.
SPECIFICATIONS
- Two large discs both at infeed side and outfeed side
- Large oscillation stroke over full width of the feed belt
- For deburring and edge rounding 3D punched parts
- For edge rounding and orbital finishing in one pass
- Working widths: 1000mm, 1500mm and 2000mm
- Smallest part size: 20mm x 20mm
- Material thickness: 0,3mm – 70mm (100mm)
