Metal Deburring Machine
General
To clean your belt disc edger and maintain its optimal performance,
follow these steps:
Turn off the machine: Prior to cleaning, make sure the disc edger
is powered off and disconnected from the power source for safety.
Remove residue: Use a brush or air pressure device to gently remove
any large particles of residue, such as dust or metal shavings,
from the machine's surfaces and individual components. If needed,
employ a vacuum cleaner or air pressure device to collect loose
residue.
Cleaning solution: Choose an appropriate cleaning fluid based on
the material being processed. This may include deionized water,
detergent, or a specialized metal cleaner. Refer to the
manufacturer's recommendations and instructions for the correct
detergent and concentration.
Prevent damage: Avoid direct contact of cleaning fluid or water
with the machine's interior or electrical components. Instead,
dampen a cloth or use a sprayer to apply the cleaning solution onto
the cloth, and gently wipe the machine's surfaces and parts.
Drying and lubrication: After cleaning, thoroughly dry the surfaces
and components using a clean cloth or paper towel. Apply a suitable
lubricant to parts that require lubrication, following the
manufacturer's recommendations.
Safety guards and devices: Clean and inspect the machine's safety
guards and devices to ensure they are free from dirt, damage, and
properly installed.
By following these guidelines, you can effectively clean your belt
disc edger and maintain its performance and longevity.
SPECIFICATIONS
- Two large discs both at infeed side and outfeed side
- Large oscillation stroke over full width of the feed belt
- For deburring and edge rounding 3D punched parts
- Working widths: 1000mm, 1500mm and 2000mm
- Smallest part size: 20mm x 20mm
- Material thickness: 0,3mm – 70mm (100mm)
