Horizontal Fiber Optic Splice Closure 2 In 2 Out Underground
wall-mounting
Horizontal type fiber closure is like a flat or cyclindrical. This
type of fiber splice closure is the most commonly used one in
mounted aerials or buried underground. Usually contains one or more
fiber splice trays to provide space and protection for fiber optic
splices. The scope of application is: aerial, underground, wall-mounting,
duct-mounting, handhole-mounting. The ambient temperature ranges
from -45℃ to +65℃.
Dimension And Capacity
| Outside dimension (LxWxH) | 370mm×178mm×106mm |
| Weight (excluding outside box) | 1900-2300g |
| Number of inlet/outlet ports | 2 (pieces) on each side (total 4 pieces) |
| Diameter of fiber cable | φ20mm |
| Capacity of FOSC | Bunchy:12-96 cores,Ribbon:72-288 cores |
Necessary Tools For Installation
| 1 | Pipe cutter | 4 | Band tape |
| 2 | Crossing/Paralleling screwdriver | 5 | Electrical cutter |
| 3 | Wrench | 6 | Stripper |
The process of installing FOSC
Type 1. In the optical cable opening of the end of the 50mm to keep the
strengthening of the reinforcement bar.
Type 2. Will need to be fused to disconnect the cable from the middle
Type3. Install and lock the cable in the cable sheath and attach the
cable to the cable.
Type 4. With electrical tape to the optical cable hoop protruding part of
the tight.
Type 5. Select the outer diameter of the cable slightly larger than the
sealing clip ring to cut off. Place the end part of the rubber
strip in the middle of the two sealing ring and use the finger to
put the glue on the cable. To maintain the natural state of the
adhesive tape or a slight force, in order to make the wrapped
layers of adhesive layers of clothing, no obvious gap.
Type 6. The cable has been installed on the sealing ring into the
connection box and cable port, will continue into the additional
support slot box, coiled cable stripping, stored into the
connection box before the space in the tower.
Type 7. Cable coil stripping, stored into the connection box before the
space in the tower
Type 8. On the first disc groove along the fiber protection groove after
hot melt pipe Around. In case of need, the remaining length can be
as shown in Figure ten Word direction coil.
Type 9. To bind the connecting plate on the connecting plate holder with a
fixed strap (which is face up) with a continuous disk.
Type 10. Close the upper and lower cover in proper order with the box body
fastening buckle.
