CET-2002P Polyurethane Adhesive For Piezo Sensors

CET-2002P

Polyurethane Adhesive for Piezo Sensors

YD-2002P is a solvent-free, environmentally friendly cold-curing adhesive used for encapsulating or surface bonding of piezo traffic sensors.

Specifications:

Package Size: 4 kg/set

Usage Instructions:

Mix components A and B thoroughly using an electric drill for 1-2 minutes.

Experimental Data:

YD-2002P is used for encapsulation and may occasionally exhibit sedimentation, especially if stored for a long period or at low temperatures. However, sedimentation can be easily dispersed using an electric drill with a wide blade.

• Color: Black
• Resin Density: 1.95
• Curing Agent Density: 1.2
• Mixture Density: 1.86
• Working Time: 5-10 minutes
• Application Temperature Range: 0°C to 60°C
• Mixing Ratio (by weight): A:B = 6:1

Testing Standards:

• National Standard: GB/T 2567-2021
• National Standard: GB 50728-2011

Performance Tests:

• Compression Test Result: 26 MPa
• Tensile Test Result: 20.8 MPa
• Fracture Elongation Test Result: 7.8%
• Adhesion Strength Test (C45 Steel-Concrete Direct Pull Bond Strength): 3.3 MPa (Concrete cohesive failure, adhesive remained intact)

Hardness Test (Shore D Hardness Meter):

• After 3 days at 20°C-25°C: 61D
• After 7 days at 20°C-25°C: 75D

Important Notes:

• Do not repack into smaller samples on-site; the adhesive should be used all at once.
• Laboratory samples can be prepared following precise ratio instructions for testing.

Installation Guide:

1. Sensor Installation Groove Dimensions:

• Recommended groove width: Sensor width +10mm
• Recommended groove depth: Sensor height +15mm

2. Surface Preparation:

• Use compressed air to remove dust and debris from the concrete surface.
• Ensure the concrete surface is dry before application.

3. Adhesive Preparation:

1. Mix components A and B with an electric tool for 1-2 minutes. (Mixing time should not exceed 3 minutes.)
2. Immediately pour the mixed adhesive into the prepared groove. (Do not leave mixed material in the container for more than 5 minutes.)
3. Flow Time: At room temperature, the material remains workable for 8-10 minutes.

Enviko

was founded in 2011, headquarter office in Hong Kong, factory located in Guangzhou & Chengdu. In 2021, we established China division in Chengdu, further enhancing our influence and service capabilities in the Asian market. We are specialized in the fields of intelligent transportation systems, smart grid systems, and civil bridge safety systems. With over ten years of experience in research, develop, and service, we are dedicated to providing the highest quality products and services to our global customers.

Two brands: Enviko and Viimax series.

Enviko represents our mature and stable products, dedicated to providing reliable and high-quality solutions. The Viimax series represents our innovative and pioneering products, constantly pushing the boundaries of technology and driving industry innovation. This dualbrand strategy allows Enviko to maintain a leading position in a highly competitive market.

Enviko is committed to providing high-quality products and services, working sincerely with partners and customers to achieve mutual growth. We will continue to pursue this strategy, constantly striving for technological innovation and industry advancement. Enviko looks forward to working with you to create a better future.