It uses a remote control automatic piercing device to damage the
relevant cables on the spot. If the cable is live, the cable will
burst immediately after being injured, otherwise the cable will not
be live.
In the process of power cable construction, when relocating and
repairing the cables that have been laid, the relevant cables are
often sawn off. In order to ensure the safety of the operators are
foolproof. The first step is to confirm the identity of the cables
to be processed on site. In particular, it is necessary to judge
whether the relevant cables are live or not. Only after the
confirmation is correct can the relevant cables be sawn off again.
There are usually two ways to confirm the identity of relevant
cables on site: confirm through the original design and
construction records; confirm on-site through the live or uncharged
cable identification instrument. There is absolutely no problem to
confirm whether the cable is live or not. At present, only the
method of using mechanical ties to make the cable relative to the
ground or short-circuit to the phase is used to determine: manual
mechanical ties and remote control automatic ties.
It is mainly composed of a controller, a remote control, and a
piercing gun body. It is a product developed by our company
independently and has a hundred shots.
★ A single gun body can only produce one short circuit point on the
cable at a time, and a double gun can produce two short circuit
points on the cable at one time.
★ It is controlled by wireless remote control, the remote control
distance is more than 10 meters, and it can be remotely controlled
by partition walls, and its safety performance is higher than
infrared. The control line is 5 meters long.
★ AC and DC dual purpose, built-in 10Ah lithium battery, long
charging time, more than 10 hours of continuous work.
★ Width of clamp diameter: 30-160mm.
★ Small size and light weight, very suitable for field use
★ Power supply: AC 220V±10% 50Hz/DC 12V 3A
