Measurement Method: Ultrasonic
Housing Material: 304 Stainless Steel or Customizable
Ingress Protection Rating: IP68
Measuring Range: 0.2 - 12 m
Blind Zone: < 20 cm
Accuracy: < 1% F.S. (Full Scale)
Ambient Temperature: -25 to 80 °C
Cable Length: Standard 10-meter dedicated cable; no intermediate connections permitted.
>>Size
>>Installation Diagram
When selecting the probe installation location, the following
standards must be followed:
○ The probe should be perpendicular to the sludge surface and the
bottom of the tank.
○ There should be no obstacles within the emission range directly
below the probe to avoid ultrasonic signals being blocked or
reflected by obstacles.
○ The probe should be installed away from areas with sudden flow
velocity changes that cause gas bubbles and activated floating
solids to ensure accurate and stable measurements.
○ The probe should be installed away from the inlet and outlet.
○ The sensor probe must be fully submerged in water. If the tank
wall is vertically straight and the surface is flat, refer to the
table below to determine the distance from the tank wall.
○ If the tank wall has an irregular surface, or has brackets,
pipes, or other objects, the distance from the tank wall must be
increased to avoid interference caused by these objects on the
measurement.
