1.Gearbox:plastic machine specially use harded gear ,long life and
low noise .
2.screw barrel:special designed screw can ensure the material
plasticizing uniform and efficient,
with heating and cooling device, ensure the stability of the
plastic melting temperature.
3.diehead:designed by ourselves and get the patent
4.clamping system:smooth running, no noise; the clamping force is
big
5.blow unit:with pre-blowing function, air blowing pin independent
design which relize convenient replacement and multiply usage
6.main Hydraulic station:Servo motor, less energy consumption, high
efficiency, low noise
7.servo station:thickness controller, response speed, control
accuracy.thickness change curve is shown, adjust simple and
intuitive.
8.frame of machine:Frame lifting can make the mould installation
easily , The highest degree of avoid rough edge
9.heating system:Heating automatic control temperature;Electrical
system is equipped with overload, overheating protection function
| Die head | Structural style |
HuaYu patent technology three layers storage cylinder die |
| Max die pin diameter | 300mm |
| Heating mode |
Nanometer insulation material heater,8pcs ,7KW/pc |
| Temperature control | Modular temperature control |
Energy configuration | Extruder driving power |
Motor with independent air cooling |
| Hydraulic main system motor power |
35.6KW servo motor |
| Wall thickness control motor power | 7.5 KW |
| Heating power of extrusion system |
6KW/pc |
| Power of die heating |
8pcs ,7KW/pc |
| Air Supply |
0.8×3(Mpa*cubic meter per minute) |
| Cooling Water Consumption |
0.3×20°×30(MPa × degree × Cubic meter per hour) |
| Total power | 399.5KW |
| Average energy consumption(AEC)
| About 200 degrees per hour |
