H-beam and channel steel cutting:
lWith web plate cutting and flange plate cutting functions;
lWith steel cutting function;
lWith flange plate beveling, the beveling angle is less than or
equal to 45 degrees;
lWith flange plate and web plate component number marking function
and single-side line drawing function;
lWith web plate Z cutting, flange plate and web plate bevel
cutting, web plate tongue cutting and other
functions;
lSupports cyclic nesting, material utilization rate is greater than
99%, and material splicing is used to
achieve extreme material saving;
lSupports cyclic cutting, and the cutting position can
automatically avoid the rib plate, web plate and flange
plate holes and corbels;
lCutting, Z cutting, and bevel cutting have local common edge
function;
lWith free-air cutting through welding holes, no edge is left
through welding holes;
lSoftware support formats: genuine Tekla's NC1 file and Solidworks'
STEP format;
lSupports manual addition of grooves, through-weld holes, component
number marking and other
functions;
lSupports manual modification of the component number or part
number of the automatically generated
original file;
lSupports component number or part number and rib plate marking of
NC1 files;
lFor upper flange plate <130mm, the hole edge of the web plate
is greater than 35mm from the inner wall of
the wing plate; 130mm≤upper flange plate, the hole edge distance of
the web plate is greater than 90mm from the
wing plate;
lThe roughness of the wing plate and web plate holes is 50 microns;
lThe function of cutting through the weld hole in mid-air has a
1mm-3mm root left
Note: In addition to the functions mentioned above, other
special-shaped parts cutting needs to be checked before
ordering.
