Industrial Clean Quartz Rotary Tube Furnace 1050C For Ceramic Sintering

Chitherm 1050 ordm C RTF3042 0611 Clean Rotary Furnace Customization for a Wide Range of Industrial Uses

Performance Parameters

• Maximum Temperature: 1000°C
• Operating Temperature: RT~900°C
• Actual Furnace Tube Size: Φ300mm×4230mm
• Heating Zone Length: 2770mm
• Number of Temperature Zones: 6 zones, K-type thermocouple
• Temperature Control Accuracy: ±1°C
• Temperature Control Method: Each zone uses a Shimaden temperature controller from Japan, with adjustable heating rate
• Heating Method: Far-infrared FEC heater
• Furnace Atmosphere: Air
• Outlet Cooling Method: Air cooling
• Heating Element: Far-infrared FEC heater
• Control Method: Imported single-loop intelligent temperature controller with PID auto-tuning
• Controlled Zones: 6 groups of far-infrared FEC heaters to ensure uniform heating
• Alarm Protection: Audible and visual alarms for thermocouple breakage, overtemperature, etc.
• Surface Temperature Rise: ≤35°C

Furnace Layout

• Transition Cooling Zone: 1 zone, approximately 840mm in length
• Heating Zone: 6 zones, approximately 2770mm in length; temperature setting range RT~900°C

Atmosphere System

• Working Atmosphere: Clean, dry, oil-free compressed air, pressure 0.4~0.8Mpa, flow rate 3~7m³/h
• Controlled Atmosphere: 1 path, controlled by a glass rotor flow meter

Equipment Installation and Usage Conditions

1. The equipment must be installed indoors, with an ambient temperature range of -15°C to 45°C. The indoor environment must be free of flammable gases, corrosive gases, and steam.

2. The equipment requires a floor area of no less than 24 square meters, with a working space length of no less than 8 meters, a width of no less than 3 meters, and a height of no less than 3 meters. The foundation must be sturdy and level, and the total weight of the furnace is approximately 2100kg.

3. The power supply for this furnace must be a three-phase five-wire AC power line, 380±10%V, 50±2%Hz. This power line must be dedicated, and large power conversion equipment such as welding machines, electric furnaces, and metal cutting machines should not be connected to this distribution.

4. The equipment must be reliably grounded.