I.the installation instructions
In order to save your precious time, this manual does not introduce
common sense of common
use of electrical appliances, please follow the common sense of
common electrical appliances.
Before using the device, please read the operating instructions
carefully so that you can quickly
become familiar with the commissioning and use of the device.
II. the installation steps
1. Connect the HDMI output of the splicing processor to the HDMI
input port of the liquid crystal
display unit, and each display unit can be connected to any HDMI
output port of the splicing processor;
2. Connect the signal source to be displayed to any one of the
HDMI1, HDMI2, and DP interfaces;
3. The first time you set up the video wall controller, you need to
connect to the RS232 interface
of the video wall controller through the serial cable.
The installation diagram is as follows:
power on
After the above cables are connected, plug in the 100-240V AC power
supply, turn on the power switch of the device,
the power indicator light is red, and the device is in working
state;
SOFTWARE COMMUNICATION SETTINGS
The first use of the 4K video wall controller needs to be debugged
by software according to the actual arrangement
of the LCD screen. Before the debugging, the control software and
the device need to communicate normally.
The following is the communication setting mode:
Open the Software folder inside the CD and copy it to the computer
hard disk, open the VideoWallcontrol.exe file inside,
and then pop up the following interface;
