1.4418 steel is a corrosion and acid resistant, soft martensitic chrome-nickel-molybdenum steel (martensitic-austenitic-ferritic mixed structure). It exhibits excellent corrosion resistance in aggressive media.

Material 1.4418 typically provides a strong combination of good toughness values and high strength.

1.4418 can be polished and is suitable for use at temperatures between -30°C and 300°C.

It is often used for mechanically and corrosively stressed components, such as pump shafts, centrifuge parts, water turbine parts in the chemical industry, automotive and aerospace industry, shipbuilding, and mechanical engineering.

Forging: If 1.4418 requires forging, it needs to be initially slowly heated to 800°C. This is followed by rapid heating between 1150°C and 1180°C. 1.4418 can then be forged between 950°C and 1180°C and cooled in a furnace, dry ashes, or other media.

Welding: 1.4418 steel can be welded with all common methods due to its low carbon content.

Corrosion resistance: 1.4418 is not susceptible to intergranular corrosion. Compared to other martensitic, stainless steel grades, 1.4418 exhibits higher resistance to corrosion due to its higher alloy content.

It also features high corrosion resistance to alkalis, weak acids, and oxidizing acids such as nitric acid. 1.4418 is resistant to fatigue and stress corrosion.

Machining: Machinability can be improved by adding small amounts of sulphur (up to max. 0.03%). However, this may have adverse effects on the mechanical properties and corrosion resistance of 1.4418.

Cold working: Cold working is possible, although cold heading is not typically carried out with 1.4418 material.

Heat treatment:

1Heat treatment condition (the number after QT indicates the minimum specified strength)

Processing:

Physical properties:

flat, forged, quenched and tempered, pre-machined

The processing with the saw is a mechanical processing of the material, which results in a significantly lower unintended deformation and increased hardness for the existing structure, such as the thermal cutting.

Thus, the machined workpiece has a homogeneous structure even at the edge, which does not change in the continuation of the material.
This circumstance allows immediate finishing of the workpiece with milling or drilling . So it is not necessary to anneal the material or make a similar operation beforehand.

Q1: How can we get the sample?
A1: Free samples are available for your checking and testing.But you need to pay for the frieght cost.
Q2: Can you provide Mill Test Certificate?
A2: Yes! The Mill Test Certificate will be issued with the product.
Q3:Packing details?
A3:Packaged 25 Tons per 20 GP wooden case container.
20ft GP: 5898mm(Length)x2352mm(Width)x2393mm(High)
40ft GP:12032mm(Length)x2352mm(Width)x2393mm(High)
40ft HC: 12032mm(Lengh)x2352mm(Width)x2698mm(High)
Q4:What is your terms of payment?
A4: 100% T/T advance.
30% T/T and balance against copy of documents.
30% T/T advance, balance L/C at sight.
Q5:Can we visit your factory?
A5: Warmly welcome. Once we have your schedule, we will arrange the professional sales team to follow up your case.