| Sign In | Join Free | My burrillandco.com |
|
Cable Electronic Testing Equipment IEC60695 Needle Flame Test Chamber Introductions Needle Flame Test Chamber is used to test the resistance of fire caused by an interior fault such as leakage current in cable ...
...Cable Testing Machine Factory wholesale automatic wire and cable elongation tensile testing equipment for comprehensive material testing. Technical Specifications Specification Value Place of Origin China Br...
...Test Equipment Introduction This vertical horizontal wire flame test equipment (VW-1) is designed according to UL1581 sect 1080.1~1080.14, and meets the criteria of VW-1(Vertical-specimen) Flame Test. It can...
...Cable Integrity Flammability Testing Equipment / Combustion Chamber 1. Description The tester is designed according to GB/T 19216.11-2003/IEC 60331-11:1999 "Line integrity test of cables and optical cables u...
... of rubber soft mineral cable. The instrument uses electric sampler to automatically display the transition resistance value and corresponding phase in the instrument with symbols and figures. It is convenie...
... very low frequency withstand voltage test. Very low frequency withstand voltage test is essentially an alternative of power frequency withstand voltage test. It is much smaller, lighter and portable than po...
... refers to IEC60332-3 test.This wire and cable fire-resistant impact test equipment is designed according to IEC 60331-12 and BS6387 -2013 standard. It is used to test if the circuit will maintain integrity ...
... 26.3, figure 19. It is used to test the mechanical strength of rewirable plugs and vehicle connector which is equipped with flexible cable. Test principle: The free end of the cable and an additional rope o...
... circuit integrity when subject to fire alone or fire with shock where the test condition is based upon flame with a controlled heat output corresponding to a temperature of at least 750˚C or fire with shock...
...Cable and Wire Shaft Pipe Vertically Burning Testing Equipment Description: Cable tester is s a fully automatic instrument contained in its own cabinet to maximize the safety of the operator. The device comp...
...Cable Halogen, PH & Conductivity Testing Equipment Introduction The International Electrotechnical Commission IEC 60754 Part 1 and Part 2 test is performed to determine the degree of acidity of gases evolved...
... voltage to test the insulation quality. The EDM sensitivity <600μA, UL1581-1990 requires the series of sparks machine using epoxy casting high-......
... cables to inhibit the vertical spread of flames under specified conditions, and the use process needs to cooperate with smoke dust removal towers. The whole machine is composed of several parts, such as a t...
...Cable Vertical Flame Spread Testing Equipment, VFT-716, IEC 60332-3, KS C IEC 60332 Product Application: Bunched cable vertical flame spread tester is used to detect vertically mounted under specified condit...
...Cable Vertical Flame Spread Testing Equipment, VFT-716, IEC 60332-3, KS C IEC 60332 Product Application: Bunched cable vertical flame spread tester is used to detect vertically mounted under specified condit...
...Testing Equipment ZY6166 For Fume Density Test Scope of application: The density testing machine for electric wire and cable is applicable to the determination of the concentration of cable and optical cable...