| Sign In | Join Free | My burrillandco.com |
|
... Tester,Cable Fault Burn Through Source Product introduction ZX-Q15 Cable high-resistance fault locating bridge tester adopts a switching power supply to form a high-voltage constant current source, uses a h...
...current and voltage are adjusted internally. The core components are high performance, high density and large-scale ASIC integrated circuit produced in the ......
...the current and voltage are adjusted internally. The core components are high performance, high density and large-scale ASIC integrated circuit produced in the ......
...the current and voltage are adjusted internally. The core components are high performance, high density and large-scale ASIC integrated circuit produced in the ......
...Source with Four Output Modes: AC/DC/AC+DC/DC+AC High-Performance Design: • Manufactured using Linear methods, featuring remote voltage feedback to ensure the test point voltage matches the set value • Stron...
...current monitor power cord spliter Features • Low cost, accurate high-side current sensing • Output voltage scaling • Up to 2.5V sense voltage • 2.5V – 20V supply range • 300nA typical offset current • 3.5A ...
...current monitor power cord spliter Features • Low cost, accurate high-side current sensing • Output voltage scaling • Up to 2.5V sense voltage • 2.5V – 20V supply range • 300nA typical offset current • 3.5A ...
... Tester , One AC Source & One DC Source I. Product description JBY-II Single Channel Relay Protector Tester is one portable tester with built-in one AC current /voltage source and one DC current/voltage sour...
... Tester , One AC Source & One DC Source I. Product description JBY-II Single Channel Relay Protector Tester is one portable tester with built-in one AC current /voltage source and one DC current/voltage sour...
...h photo diode and current amplifier. This IC can be used to Brightness control and on-off control of light sources such as a display. And Improvement in display visibility, the improvement in a life of a lig...
... significantly Variable the wave form itself. This is often a requirement in Dense Wave Division Multiplexing (DWDM) and Erbium Doped Fiber Amplifier (EDFA) applications where the receiver cannot accept the ...
... dynamic control of optical power levels in a fiber. It can be applied to adjust power level of signal in the optical communication at the output of light sources, E/O converters and for the linear or dynami...
...Variable Optical Attenuator Single Mode Variable in-line optical attenuators comprise a dual fiber collimator and a reflection component separated by a linear moveable ND filter. They are used to permit dyna...
... significantly Variable the wave form itself. This is often a requirement in Dense Wave Division Multiplexing (DWDM) and Erbium Doped Fiber Amplifier (EDFA) applications where the receiver cannot accept the ...
Variable Speed Drive 90KW 3 Phase 380V 220V Frequency Inverter Description of variable frequency drive Our raw materials are sourced from top-quality suppliers, ensuring cost-effectiveness, reliability, and qu...
...Variable Frequency Drive For Industrial Automation Machine Description of variable frequency drive Asynchronous motors driven by three-phase AC asynchronous motors can be perfectly controlled by ST-310 serie...
FR-A820-01870 30-45kW; 3x200-240V;In max: 187A;(37kW; 145A); IP00 Inverter Series FR-A SERIES Type FR-A800-E INVERTER Minimum Rated Voltage (V) 200 Min. Permissible Voltage (V) 170 Maximum Rated Voltage (V) 240...
... analog, digital, and RF integrated circuits, widely used in aerospace, military, medical, automotive, and consumer electronics. We offer product sourcing, design support, and...
... switching rectifier/power suuply/ Smaller and lighter compared with 4th generation rectifier. Some pics was followed Application Different volt and current has different applications Specification SPECIFICA...