| No. | Name | Unit | Qty |
| 1 | Decoiler | set | 1 |
| 2 | Main machine for roll forming | set | 1 |
| 3 | Control system | set | 1 |
| 4 | Hydraulic system | set | 1 |
| 5 | Post cut | set | 1 |
| 6 | Output table | set | 1 |
Techical description:
A Manual decoiler
Inner Diameter: Φ450 – Φ600 mm
Out Diameter: 1500 mm
Max. Loading Capacity: 5000 kgs
B Roll-Forming M/C:
Material thickness:0.3-1.0mm
Feeding and effctive width depends on profile drawing
Steps:11/13 (for standard drawing)
Roller Material: 45# steel
Diameter of active shaft: 70mm
Wall thickness of the main forming machine: 14mm steel plate
Main forming machine body : 300mmH steel
Main Motor Power:4KW
Voltage:380V/50Hz.
Line speed:8-12m/min;
Rolling chromium thickness:0.05 mm
C Cutting device
It adopts hydraulic drive and automatic location to decide the
dimention and cut the target products.
Cutting length tolerance: ±2mm
Cutting tool material: GCr12 with quenched treatment 55-60°C
D Hydraulic System
It is controlled by gear wheel oil pump. After filling the
hydraulic oil into the hydraulic oil tank ,the pump drive the
cutter machine to begin the cutting job.
Match equipment: a set of hydraulic tank , a set of hydraulic oil
pump, two hydraulic pipes and two sets of electromagnetism valves.
Power of the oil pump: 3kw
Hydraulic oil :40#
E Control system:
Type: PLC Frequency Control System with touch screen
PLC Brand: Japan Panasonic
Encoder Brand: Omron
Length Error:±1mm
Transducer: Panasonic
F Output table
It is smpile and used to load the finshed product.
Lenght:6m
