FSCUT 1000 Cypcut Fiber Laser Cutting Machine Laser Controller
System
Basic introduction
The FSCUT1000S system is a set of low-cost fiber laser cutting
solutions tailored on the FSCUT2000C medium-power laser cutting
system. The system combines the motion control card and the
capacitor height controller into one, and is a special laser
cutting system with high cost performance.
Feature
1.Craft
Supports up to two levels of perforation.
Only supports the communication of domestic lasers such as Raycus,
Maxphotonics and Feibo.
Support flying cutting, leapfrog.
Capacitive edge finding is not supported; the expansion board can
support electric focus adjustment and double exchange worktables;
support simple layout.
Advanced processes such as cooling spots, sharp corners, and
release corners are not supported.
2.Control
Track accuracy 0.05mm, positioning accuracy 0.01mm.
Maximum cutting speed 100m/min, maximum idle speed 100m/min.
Maximum acceleration 1G.
Does not support dual-drive error alarm and pitch compensation
functions.
The origin signal is not supported, only the limit signal is
sampled when returning to the origin.
Applicable Industries
It is suitable for low-power fiber laser cutting machines within
1500W, and is widely used in laser processing equipment for thin
metals such as the advertising industry.
 |
| FSCUT 1000 |
Specification
| Adaptation software | CypOne Laser Cutting Software |
| Control card | BMC1603 |
| Interface Type | 32-bit PCI bus, 132MB/s |
| Terminal board | BCL4562 |
| Power Requirements | 24V DC/2A |
| Motor control signal | X/Y1/Y2 axis pulse output, maximum frequency 3MHz
Z axis analog output, -10~+10V
X, Y1, Z axis with encoder input interface, the highest sampling
frequency 10MHz |
| Dedicated output | 2-channel DA: 0~10V, 50mA
1 channel PWM: 5V/24V optional, accuracy 5KHz (0.1%) |
| Dedicated input | 6-way limit: X/Y1/Z 3-axis positive and negative limit |
| Universal input | 6 channels: active low, support normally open, normally closed |
| Universal output | 8 channels: relay output, 30V DC/5A |
| Working environment | Temperature: 0~55℃
Humidity 5%~95% (non-condensing) |
