Zimmer Tapered Screw-Vent® Titanium Premill Blank 10mm NP(3.5mm) /
RP(4.5mm) / WP(5.7mm) Custom Fabricated Abutment
Material:
Ti 6AI-4V ELI (Supply from Germany)
Feature:
* Simply efficiency
* Precision machined up to ± 5µm
* Benefit from a faster and controlled turnaround time
* Different diameter available of 10mm, 14mm
Pre-milled Abutment Blanks, you can now produce titanium customised
abutments with your milling equipment.
Boost your efficiency by using your milling machines and benefit
from all major implant connections.
Approved by CE, ISO 9001, ISO 13485
* We also can provide another 3 type of premill as above picture
shown. Welcome to further inquire. Thanks.
Points of Zimmer Tapered Screw-Vent® (TSV) Implant:
Fig. 1
Tapered Screw-Vent® titanium grade 5 implants are machined with a
slightly tapered body geometry and triple lead thread design. The
triple lead threads will force the implant at a faster rate in to
the osteotomy site as compared to a single lead thread design
implant. Four implant diameters (Fig.1) of 3.7, 4.1, 4.7 and 6mm in
five lengths of 8, 10, 11.5, 13 and 16mm are available from Zimmer®
for this implant system. 3.7 and 4.1mm diameter implants share the
same implant/abutment interface (platform) of 3.5mm. 4.7mm diameter
implants are machined with a 4.5mm implant/abutment interface and
6.0mm diameter implants are produced with a 5.7mm platform. The
implant/abutment interface consist of a internal hexagon which is
dimensioned according to the platform diameter.
Fig. 2
Each of the implants is packaged with a cover screw and color coded
fixture mount. The color coding scheme is carried throughout the
complete implant system for easy platform identification. Green
signals the 3.5mm platform, purple signifies a 4.5mm platform and
yellow corresponds to the 5.7mm platform. The fixture mount may
serve as a delivery device, impression coping and temporary
abutment. A oblong lacuna at the apex of the implant creates
cutting surfaces and serves as a reservoir for bone chips. Two
options are available in regards to the extent of the surface
treatment at the coronal aspect (Fig.2) of the implat. Option one
is a 1mm machined collar separating the textured area from the
implant/abutment interface and option two extendes the textured
area to the edge of the implant/abutment interface with added micro
groves at the coronal aspect.
