Pool Enough Power High Head Big Flux Hydroponics Water Pump With
PPO Impeller
| Model | Voltage | HZ | Power(KW) | Power(HP) | Hmax(m) | Qmax(m³/h) | Port Size(inch/mm) |
| FL-150 | 220V-380V | 50/60 | 1.1 | 1.5 | 18 | 30 | 63 2” |
| FL-200 | 220V-380V | 50/60 | 1.5 | 2.0 | 19 | 35 | 63 2” |
| FL-300 | 220V-380V | 50/60 | 2.2 | 3.0 | 20 | 38 | 63 2” |
| FL-350 | 220V-380V | 50/60 | 2.6 | 3.5 | 21 | 40 | 63 2” |
| FL-400 | 220V-380V | 50/60 | 3.0 | 4 | 22 | 48 | 63 2” |
Features:
1. Unit nameplate data or serial label number
2. Description of part
1) Magnificent flow rate and lift, the core energy of water
circulating, 2~3m suction lift
2) Engineering plastic body, the pump can be effectively protected
under bad weather,
long service life;
3) Seiko manufacturing, low noise during the pump working time;
4) Free-tool filter cover design, easy to maintenance;
5) IP55 protection level, with None-leaky design;
6) German technology IBC bearing, 100% copper wire motor, 24 hours
running.
7) Anti-rust cast-aluminum motor cover, fast heat dissipation; PPO
plastic steel material
impeller, resist high temperature and corrosion
8) Silicone sealing ring cover all watering section, enhance pump
sealing system
9) CE certificated, reliable and safety
These pumps are suitable for handing clean water not containing
abrasive particles and fluids which are not chemically aggressive
to the pump components. reliable, compact, economic and simple to
use, They are particular suitable for domestic and swimming pool
applications such as water supply for recirculation in air
conditioners and refrigerators, industrial water uses in general,
and the automatic distribution of water from surge tanks, watering
gardens, lifting water from tanks or wells down to 9m depth. These
pumps should be installed in a covered area, protected against the
weather.
Working Conditions:
M edium temperature:5~50 C
Environment temperature:< 60 C2. Application :
FRE ESEA circulation&filtration pump canbe used for
aquaculture, water project, large sizeswimming pool,water park,
etc.
Pump Use Precautions:
1. If the pump has any small faults, remember not to let it work.
If the filler of the pump shaft is worn out, it should be added in
time. If the pump is used continuously, it will leak. The direct
effect of this is that the motor consumes more energy and can
damage the impeller.
2. If the pump has a strong vibration during use, be sure to stop
and check what is the cause, otherwise it will cause damage to the
pump.
3. When the bottom valve of the pump leaks, some people will fill
it into the inlet pipe of the pump with dry soil and flush it to
the bottom of the valve. This is not desirable. Because when the
dry soil is put into the water inlet pipe, when the water pump
starts to work, the dry soil will enter the pump, which will damage
the water pump impeller and the bearing, which shortens the service
life of the water pump. When the bottom valve leaks, it must be
repaired. If it is serious, it needs to be replaced.
4, the pump must pay attention to maintenance after use, for
example, when the pump is used up, the water in the pump should be
cleaned, it is best to remove the water pipe and then rinse with
water.
5, the tape on the pump should also be removed, then rinse with
water and dry in the light, do not put the tape in a dark and humid
place. The tape of the pump must not be stained with oil, and do
not apply some sticky material to the tape.
6. Carefully check the impeller for cracks. If the impeller is
fixed on the bearing, if it is cracked or loose, it should be
repaired in time. If there is mud on the pump impeller, it should
be cleaned up.
