Good Flex Characteristic U Type Lock PC Hollow Cross Section Mould
Series
Descriptions :
Mould core rod adopt the special equipment cut, and the high
precision polishing process to make sure the smoothly flowing of
the materials.
In the die head, the elastic fine-turning design make the tolerance
of the product wall thickness ≤3%. Fully built-in zone control
electric heating tube, safe and look good. The mould adopt the heat
shield device to realize optimization of process temperature in
order to reduce the loss of heat. The even vacuum system and the
temperature control system which are separately zone controlled by
the calibrator mould equip the vacuum sealing strip equipment. The
mould can be used to produce U type lock PC hollow cross-section
products, thickness range from 4 to 40mm and width range from
600-1050mm.
The PC hollow products produced by special dies are light weighted,
high impact strength, easy installation, good flex characteristic,
is widely used as large municipal engineering, the roof of the
building. Such as roof of swimming pool, industrial roof, lighting
ceiling, agricultural greenhouses and so on communal facilities.
- Extrusion Die Repair Upgraded
We will provide you a whole set standard service with general
maintenance, die clean, examination, repair, upgrade, renovate and
so on. After renovates the die, it can achieve or very close to the
initial standard.
Every need to repair the die we will strictly according to the
following steps :
Die remove, cleaning.
Inspection, evaluation and communicate with customer requirements
for renovation.
Faded except the original chromium plating.
Repair damaged surface defects or change the defects in design.
Replace damaged parts.
Repairing mold body joints.
The mold flow channel to polish.
Reassemble the die.
Proofreading technical specification.
