The description of 200BPH 5 Gallon Semi-aurto De-capper And Brush
Washer Water Filling Machine line system
Product description
1.Semi-auto de-capper and washer
Worker put used jar in right side of de-capper position, with the
neck inserting into the hole, worker
foot press pedal to release cap off neck; And then worker need to
take the jar to insert into left side of
the machine-washing position. After the jar putting in, the window
need to be closed. Then the washer
will be started by itself. During washing, the inner brush inside
jar and Washing time is pre-settled, the
machine will stop when time finish. Heating function could be
switched on/ off as client’s needing.
2.Monoblock rinser-filler-capper
water. The whole machine is using stainless steel 304 ,rot
resistant,can be cleaned easily.Main electric
parts are all branded. Air channel system use Air TAC brand
product.The machine is with compact
construction,will occupy small room,working efficiency is high.Only
need 2 operators to control, is a
good choice for factory to choose.
The machine set up do not need plug floor screw,after case taking
off,set the machine on the flat
floor,and then adjust stand height and adjust all stand pressure to
be average. After the machine is set
up well, get in through water pipe, drain pipe and power , air
power
Working process:
1. Set empty barrel mouth to barrel seat, empty barrel will be
washed during headstand situation,4 working station for barrel
inserting.
2.Washing process will be divided into 4 steps:1, hot alkali water
washing 2,thimerosal washing；3,clean water washing,4,pure water
washing.Every washing step is set to 8S,afterwashing,there will be
10S for dripping.
3. The barrel after washing will move down 45 degree through the
passing chain and will passing out chain and turn over 45 degree by
barrel lift cylinder to filling position for filling.
4 .Filling value will driven by cylinder to insert into barrel and
start to fill, filling time is controlled by PLC, and filling time
is adjustable by control panel according to filling liquid
surface.After filling,the extra water will back to pure water tank
by automatic vent,it can reduce waterconsumption.(water tank is not
included)
5.After filling process finish,the filled barrel will be pushed to
capping position by barrel stop cylinder,the whole process finish
till now
Technical parameters
| Model | QGF-200 |
| Filling heads | 2 |
| volume(L) | 18.9 |
| Barrel size(mm) | ∅270*490 |
| Capicity(b/h) | 200 |
| Gas pressure(Mpa) | 0.4-0.6 |
| Gas consumption(m3/min) | 0.37 |
| Motor power(KW) | 1.75 |
| Rated voltage(v) | 380v/50HZ |
| wEIGHT(kg) | 800 |
Product Pictures:
