Best Factory Wholesale 40-50T Pile Driver Arm For SANY CAT HITACHI
KOMATSU DOOSAN VOLVO CASE
The piling arm is special for excavator piling and configuration
arm, and excavating special arm is different, the piling arm is
straight arm, which is conducive to lifting high, equipped with a
short forearm, the bending arm of the piling hammer can be
connected with the forearm, better control the piling and piling
operation of the piling hammer
The characteristics of the pile arm of the excavator:
1, full hydraulic drive, can rotate around 180 degrees operation,
simple operation;
2, convenient transportation, can be connected with the excavator
as a whole;
3, can be used in a variety of work sites, rainy days can also be
in the river, water, underwater operation;
4, can play, dial steel pile, cement pile, rail column, iron plate,
H plate, drainage belt;
5, the use of Germany's original hydraulic motor drive (rotary
motor and vibration motor), small size, light weight, but can
output high power and high speed, high reliability, durable;
6, advanced oil design, so that the stuck pile and vibration
synchronous, improve the efficiency of playing, shifting pile,
better protect the main oil system of the excavator, the new design
of safety device, when the vibration operation safety device makes
the chuck automatically tightened, not loose pile plate, safe and
efficient;
7, the cylindrical rod bearing imported from Japan, low noise, high
speed, high reliability, the quality of the whole machine is
better;
8. When driving and pulling piles, the speed and vibration
frequency can be adjusted to meet the requirements of different
working environments;
9, optimize the design device, the ends of the protection pile is
not easy to damage, in the building close operation will not damage
the building itself;
10, the use of well-known brand shock absorber, reduce vibration
noise, more in line with the requirements of environmental
protection, improve the lasting reliability of the machine.
Notices: All pins and linkage assembly use the original one, and the high
pressure hose of the arm cylinder also use the original one. The
steel pipe above the large arm is designed in sections to
facilitate the later maintenance.
| Excavator Ton | Total Length(mm) | (A)Boom(mm) | (B)Arm(mm) | (C)Piling Height(mm) | Counter Weight(Ton) |
| 30-36T | 13800 | 10000 | 3800 | 15400 | 3T |
| 30-36T | 15000 | 10500 | 4500 | 17100 | 5T |
| 40-45T | 15800 | 11000 | 4800 | 17900 | 3T |
| 40-45T | 16800 | 11500 | 5300 | 18500 | 5T-6T |
| 45-50T | 19000 | 12500 | 6500 | 21000 | 6T-7T
|
