Minute Leave machine install Complete Hold do regulation but
The separator is a high-speed rotating machine, and the drum
generates huge centrifugal force when it is working. In order to
ensure the safety of operators and equipment , the following rules
should be strictly followed during use:
- Before the main lock cap of the drum is locked and the inlet and
outlet devices and other fastening screws are not fastened, the
separator cannot be started. Do not loosen any part of the machine
until the drum has come to a complete stop.
- Flame heating or repair welding of all parts of the drum is not
allowed.
- If there is abnormal vibration and abnormal sound when the
separator is working, it should immediately cut off the power
supply and stop it immediately.
- Parts of the drum cannot be exchanged with other drum parts, even
the same type of separator is not allowed.
- When the "O" assembly mark of the main lock cap crosses the
corresponding mark of the drum body by more than 25°, Users should
stop using it immediately and contact our company in time.
- The separator must not be used to process materials that are more
corrosive than the factory design.
- In the process of use, if the wear of the drum body exceeds 1mm,
the user should stop using it immediately and contact our company
in time.
- If the main parts of the separator are found to have quality
problems, we must notify our company in time, and users are not
allowed to replace and repair without authorization, so as not to
damage the machine and affect safe production. Please use the spare
parts provided by our company.
- When the separator has been used for two years or its vibration
intensity exceeds 4.5mm/s and cannot be reduced, non-destructive
testing of the drum parts and shafts must be carried out and the
dynamic balance of the drum part must be checked. Flaw detection
will be required every year thereafter.
If the user violates the above operating rules, all the
consequences arising therefrom shall be the responsibility of the
user.
一 The main technical parameters of a separator
- Model KYDR204
- The inner diameter of the drum 250mm
- The speed of the drum about 8350r/min
- Counter speed 120r/min
- Separation factor 9760
- Rated capacity ～2000L/h
- Motor model Y112M-4 B5
- Power 4 kw
- Dimensions (LxWxH) 918mmx545mmx924mm
- Mass ～310 kg
二 working principle
Using the principle of obtaining different sedimentation velocities
in the centrifugal force field by using the light, heavy or solid
phases with different densities and immiscible in the mixed liquid
(mixed corrosion liquid), the separation and stratification or the
sedimentation of solid particles in the liquid are achieved.
Purpose.
The separated material is fed into the heart of the machine, that
is, the inside of the drum. Under the action of a strong
centrifugal force, the material (mixed liquid) passes through the
separation interval of a set of disc bundles. The neutral hole of
the disc is used as the interface, and the specific gravity The
larger liquid (heavy phase) moves along the disc wall to the
outside of the neutral hole, where the heavy slag accumulates in
the sediment area, and the liquid (light phase) with a smaller
specific gravity moves upward along the disc wall and converges to
the small centripetal pump , output from the small centripetal
pump.
