3D/4D Probe Dome Replacement Oil and sealing GE RIC6-12-D Array
replacement
We provide repair service on most common probes, 3D/4D transducers,
and Endo/TEE probes.
With 10 years experiences on probe repair, our technical engineer
team own the most advanced probe repair processes, which enables us
to fix probes from a basic lens fault to 4D /TEE fault.
Once repaired, all probes will go through an extensive testing
process ,until reach their optimal condition.
Other hot GE models we can repair:
| GE | C1-5-D |
| GE | C1-5-RS |
| GE | 4C |
| GE | 4C-RS |
| GE | 4C-A |
| GE | 4C-D |
| GE | 4C-SC |
| GE | E8C/E8C-RS |
| GE | E8CS |
| GE | RIC5-9-D |
| GE | 3CRF-D |
| GE | C1-6-D |
| GE | RAB4-8-RS |
| GE | RAB2-5-RS |
| GE | 6S-RS |
| GE | 12L-RS |
| GE | 3SC-RS |
| GE | L6-12-RS |
| GE | 11L |
| GE | 11L-D |
| GE | 12L-RS |
| GE | 8C |
| GE | 3S |
| GE | 3S-RS
|
Common ultrasound Probe Damage(Specialty 3D/4D Volume probes)
| Common ultrasound probe damage | Solutions |
| Lens cap damage | Lens cap replacement |
| Fluid and oil leaks | Lens cap replacement, oil reservoir repair and replacement |
| Cable cuts | Cable patches, possible cable replacement |
| Inoperative steering | Motor repair |
| Connector housing electrical damage | Minor electrical repairs, pin module replacement |
| Weak or dead elements, dropouts in an image | Array ball replacement, oil reservoir repair and replacement |
Probe Troubleshooting Summary
1. Check whether multiple probes are the same phenomenon, sometimes
it is necessary to plug again
2. Lens and crystal failure are sometimes similar, both are
shadowing on the image
3. If there is a single probe problem, replace the socket to have a
check.
4. The high frequency probe (small parts probe) is sensitive. If
only this probe doesn’t work, may be caused by machine failure.
