NBSANMINSE SRYZ 2.0Mpa Thin Oil Lubrication Pump AC380V AC220V With
Overflow Valve Pressure switch Controller
Performance and characteristics
. Specific work pressure : Sets the overflow valve, To prevent oil
pump overload.
. With unloading function : can stop working after removing the oil
pressure in the system, mainly used in the quantitative type
(pressure type or Pressure relief type) the thin oil lubrication
oil supply system.
. Equipped with a hydraulic switch (closed with lack of oil
10W/DC100V/0.5A), but will output oil tank shortage signal
. Inside the pump with pressure switch (normally open
AC220V/2ADC36V/2A), to monitor the lubrication system that the main
oil line block and the pressure loss (optional parts)
. Inside the pump can match the PC-2 display controller, control
the operation tie and off tie (optional parts)
. Transparent resin oil tank or metal oil tank
. Use the lubricant viscosity : 32~2500cst
. Assort distributor : Pressure or pressure relief type thin oil
distributor
Attention
. Pressure switch as much as possible installed at the end of the
system main pipe, not within the oil pump, it can more correctly
detected the lubrication system condition with main pipe blocks the
flow and pressure loss
.If the host with PLC, should by the host PLC control oil pump run
tie and rest tie, the oil pump without set controller; But if the
host does not PLC or with PLC wiring is not convenient, the oil
pump shall set the controller to the countdown control lubrication
pump working cycle : run time and rest time.
. If the working power supply is not AC380V 50Hz, should indicate
the power and HZ when order power supply
. RYZ series pump as an example illustrates the specific technical
parameters, it is same technical parameter with a pressure switch
or controller with same specification.
. Example: the rated flow 0.5L/min, oil capacity 4.0L, Rated
pressure 2.0MPa, the working power supply is AC380V50Hz, without
pressure switch and controller of RYZ series thin oil pump models
for RYZ-1; lubrication pump with a pressure switch (optional), type
of RYZ-1P; lubrication pump with a controller (optional), type of
RYZ-1C; If the work is specific power requirement, when you order
it should indicate the voltage and frequency, such as
RYZ-1/460V60Hz
| Project | Rated pressure (Mpa) | Rated flow (L/min) | Oil tank capacity (L) | Electric machine parameter | Fuel tank |
| Voltage (V) | Frequency(Hz) | Power (W) | Revolving speed (r/min) |
| Model |
| RYZ-2 | 2.0 | 0.25 | 2.0 | AC380 | 50 | 60 | 1350 | Transparent resin |
| RYZ-1 | 0.5 | 4.0 | 90 | 2700 | Transparent resin or metal |
| RYZ-3 | 6.0 |
| RYZ-4 | 9.0 |
