SANMIN SDR Thin Oil Lubrication Pump 3 liter 4 Liter 6 liter 8
Liter with 2Mpa Pressure switch and controller for Lubrication
system
Performance and characteristics
. Rated working pressure 2.0Mpa : Sets the overflow valve, prevent
oil pump overload
. With functions of unloading : Stop working after removing the oil
pressure in the system is in charge of road, mainly used in the
quantitative type (pressure type or unloading type) thin oil
lubrication oil supply system
. Equipped with a hydraulic switch (closed with lack of oil
10W/DC100v/0.5A), will ouput oil tank shortage signal
. Inside the with pressure switch (normally open AC220V/2ADC36V/2A
), to monitor the lubrication system that the main oil line block
and the pressure loss (optional parts)
. Inside the pup can match the PC-2 display controller, control the
operation tie and off tie (optional parts)
. Transparent resin oil tank
. Use the lubricant viscosity 32~2500cSt.
. Supporting distributor : pressurized or pressure relief type thin
oil distributor
Attention
. Pressure switch as much as possible installed at the end of the
system main pipe, not within the oil pump, it can more correctly
detected the lubrication system condition with main pipe blocks the
flow and pressure loss
. If the host with PLC, should by the host PLC control oil pump run
tie and rest tie, the oil pump without set controller; But if the
host does not PLC or with PLC wiring is not convenient, the oil
pump shall set the controller, the controller to the countdown
control lubrication pump working cycle : run time and rest time.
. If the working power supply is not AC380V 50Hz, should indicate
the power and HZ when order power supply
. The following from is without pressure switch and controller of
the SDR series pump as an example illustrates the specific
technical parameters, it is same technical parameter with a
pressure switch or controller with same specification.
. Example: the rated flow 0.5L/min, oil capacity 3.0L, Rated
pressure 2.0MPa, the working power supply is AC380V50Hz, without
pressure switch and controller of SDR series thin oil pump models
for SDR5-32; lubrication pump with a pressure switch (optional),
type of SDR5-32C; If the work is specific power requirement, when
you order it should indicate the voltage and frequency, such as
SDR5-32/460V60Hz
| Project | Rated pressure (Mpa) | Rated flow (L/min) | Oil tank capacity (L) | Electric machine parameter | Code Type |
| Voltage (V) | Frequency(Hz) | Power (W) | Revolving speed (r/min) |
| Model |
| SDR2.5-32 | 2.0 | 0.25 | 3.0 | AC380 | 50 | 60 | 1350 | 1.With pressure switch model after P, Like SDR2.5-32P. 2.With
controller model after C, Like SDR2.5-32C 3.Indicate the power,
Like SDR2.5-32/AC460V60Hz |
| SDR5-32 | 0.50 | 90 | 2700 |
| SDR2.5-42 | 0.25 | 4.0 | 60 | 1350 |
| SDR5-42 | 0.50 | 90 | 2700 |
| SDR2.5-62 | 0.25 | 6.0 | 60 | 1350 |
| SDR5-62 | 0.50 | 90 | 2700 |
| SDR2.5-92 | 0.25 | 9.0 | 60 | 1350 |
| SDR5-92 | 0.50 | 90 | 2700 |
