Dukane 110-3122 Replacement Type Transducer
Description:
An ultrasonic transducer is an energy device that converts
electrical energy, mechanical energy, or acoustic energy from one
form of energy to another, called a transducer, also known as an
active sensor. One of the most mature and reliable is the device
that converts electrical energy and acoustic energy by
piezoelectric effect, also known as piezoelectric transducer.
Specification:
Frequency: 20Khz
Input Power: 2000w
Joint Bolt: 1/2 - 20UNF
Ceramic disc Diameter: 50mm
Quantity of Ceramic disc: 4 pcs
Capacitance: 11nf
Application: Welding
Advantages:
1. Low calorific value.
2. Good thermal stability.
3. The frequency is consistent with the static capacitance.
4. The resonance impedance is low.
5. Long average life.
6. Can be used in a variety of ultrasonic equipment
Application:
Ultrasonic transducers are widely used. They are divided into
industry, agriculture, transportation, life, medical and military
according to the applied industry. According to the functions
realized, it is divided into ultrasonic processing, ultrasonic
cleaning, ultrasonic detection, detection, monitoring, telemetry,
remote control, etc.; according to the working environment, it is
divided into liquid, gas, biological, etc.; according to the
nature, it is divided into power ultrasonic, ultrasonic detection,
ultrasonic imaging, etc. .
FAQ:
1. How to judge whether the transducer is damp, what should I do if
it is damp?
The ultrasonic vibrator is damp. You can check the plug connected
to the transducer with a megger. Check the insulation resistance
value to judge the basic situation. Generally, the insulation
resistance is greater than 5 megohms. If the insulation resistance
value is not reached, the transducer is generally damp. The whole
transducer (excluding the sprayed plastic case) can be placed in
the oven for about 3 hours at 100 °C or use a hair dryer to remove
moisture until the resistance is normal.
2. What is the cause of sparking when the ultrasonic transducer is
working?
1) The humidity in the working environment or the oil in the air is
relatively large, resulting in a small insulation between the
positive and negative electrodes of the transducer.
2) The ceramic piece of the transducer has cracks.
3) The transducer electrode piece should be broken.
4) Welding line is desoldered.
5) Ultrasonic power supply output voltage is abnormal.
