Semi Auto Stitcher Carton Making Machine , Cardboard Box Making
Machine
5. The actual process of the nail box: The feeding of the cardboard
is carried out by the servo motor, and the nail motor drives the
nail head to complete the nail box. The drive shaft driven by the
nail head motor and equipped with the clutch and the brake drives
the crank mechanism to realize the nail box action under the action
of the clutch. When the first nail action is completed, the
cardboard back panel picks up the cardboard, and the crank
mechanism moves in a stepwise manner. Drive the paper feed roller
to rotate, stop after reaching the predetermined nail distance, and
immediately perform the second nailing. Troubleshooting
6. The nail head does not nail. The nail head motor does not run.
Check if the solenoid valve trips. The nail head clutch has no
action. Inside the nail head, remove the nail head side cover and
take out the punch to clean, refill after adding lubricating oil.
The auto start switch does not start. The single-chip, two-piece
selector switch is placed in a single piece, and the nail cannot be
automatically stapled when the paper is fed. The upper nail head
baffle photoelectric sensor switch does not operate, and adjusts
the photoelectric switch sensing distance. The axis of the lower
rail is not sensed, causing the paper to be pinned without being
fed.
7. Continuous nailing of the nail head The solid state relay is
damaged and the DC solid state relay is replaced. Proximity sensor
switch failure.
8. Incorrect positioning of the nail head Check the F3 fuse 34-35
(AC). F9 fuse 50-51 (DC). The brake coil resistance wire is 15Ω.
9. The left and right paperboard tooth type paper feeding belt does
not run. The screen displays the servo abnormality. Turn off the
total power supply in the electrical box for 3 minutes and turn it
back on. Check if the toothed belt drive pin slot shaft can be
rotated. After troubleshooting, press the screen to indicate the
reset button to resume operation. When the servo motor is
overcurrent, press the white plastic handle under the 10Hp
electromagnetic switch of the control box to recover.
10. Left and right paperboard paper feeding belts continue to run
after nailing. The right sideboard counts the photoelectric
induction intensity too strong. Adjust the one-side knob on the
side of the electric eye, the clockwise strength increases, and the
counterclockwise direction weakens.
Machine specification
| Max size (A+B)X2 | 3600mm | min length A | 250 mm |
| Min size A+B)X2 | 740mm | Max height D | 2000 mm |
| Max size (C+D+C) | 3000mm | Min height D | 150 mm |
| Min size (C+D+C) | 250mm | Max flay size E | 40 mm |
| Min cover size C | 50mm | Max paper heigh | 900 mm |
| Max cover size C | 560 mm | Machine width | 2850 mm |
| Max width size B | 760 mm | Machine weight(T) | 2tons |
| Min width size B | 120 mm | Machine speed (nail/min) | 500 |
| Max length A | 1120 mm | Nail no. | 1-99 |
