Plastic Pellet Dryer CSG Plus 4000 Energy Saving & Low Dew Point
Hopper Dryer
CSG 4000 Dehumidifying Dryer
Introduction of CSG
CSG series is a fully automatic drying system with zeolite
desiccant beds, which Can be used with Hopper Bank Series and
multi-hopper systems. It can adapt and automatically control
operating parameters based on type and quantity of polymer.Up to
40% energy saving in comparison with traditional dryers.
Product Description
This series expands CSG standard series maintaining its
characteristics while offering increased production capacity.
Its advanced thermodynamics based on Zeolite trible tower design
with three desiccant cartridges and three pumps technology: two to
process air production and one for saturated tower regeneration.
Feature
1. Automatic start/stop timer one week to improve energy saving.
2. Drying hopper and hopper lid can be fully insulated for high
temperature application.
3. Option accessories: euro-hopper suction box, euro-hopper mobile
floor stand, material door magnet,
magnetic base(aluminum or stainless steel), blower inlet filter,
hot air recycling, exhaust air filter.
4. Europeanization design, double-wall with imported thermal
insulation material filled in interlayer,
shorten the heating time and reduce heat loss, therefore saving
energy & high efficient.
5. Hot air down-blowing design ensures even distribution of hot air
to maintain a steady temperature in the
hopper and increase drying efficiency.
Main Advantages
1.No moving or rotating internal parts.
2.No need of manual control, Full auto-adaptive operation.
3.On-board heating unit on hopper.
4.Diagnostic functions,Dewpoint, heater, and temperature alarm.
5.Visual and audible alarms available.
5.Anti-stress function protecting polymers against overheating.
6.Automatic dew point control system: not switch to new desiccant
bed before the dew point gets -30°C.
Dew Point Control
Instead of superficial time control, now we precisely control our
pneumatic value on the basis of dew point. It’s the energy
consumption solution with highest cost performance.We have the
best-matched regeneration control and control the frequence of
regeneration according to the moisture content. The most efficient
energy consumption, no earlier or longer, just the right time with
no waste.
Air volume control
According to all the data collected by the system, through ABB
frequency converter, we can control fan power and air volume, avoid
risk, improve efficiency and save energy! The traditional drye
cannot control air volume, which wastes energy, and increases the
loss. If air volume is fixed and the fan configuration is not
adjustable, the full amount of air must be configured. when the
output is not high and the raw material is dry, it is not necessary
to have such a large amount of air, so the surplus is wasted.if
using ABB inverter, the air volume can be provided on demand, the
raw material can be dried uniformly, thus, the finished product
quality is guaranteed.
