Portable Hand Held Electric Pipe Beveling Machine for Mechanical
Pipe Edge Preparation
Product Introduction
Our portable handheld pipe beveling machines for mechanical pipe
edge preparation and orbital welding makes the job easy to be done
on-site or in the workshop. The pipe beveling machine is fixed on
the workpiece with an inside or outside clamping mechanism. It's
designed for simultaneous facing and beveling tubes and pipes
(including carbon steel, alloy steel and stainless steel) from
12.5mm to 240mm I.D. up to a wall thickness of 0.75" (18mm).
Application Industries
■ Energy Field
Oil Refinery
Offshore Engineering
Power Plant
■ Process Engineering
Electronic Equipment
Medicine
Biotechnology
Food and Beverage Industry
■ Construction and Construction Equipment
Water and Gas
Water and Treatment
Heater
Basic Info.
| Brand | Bohyar |
| Model | BPP1E Kit1 |
| Drive Mode | Electric |
| Electric requirement | 220-230V 1PH 50/60HZ |
| Power | 1.43KW |
| Application Range (I.D.) | 12.5mm-15mm |
| Wall Thickness | ≤3mm |
| Rotating speed | 3-70rpm |
| All standard accessories included |
*Electric: Rated voltage of 220V, 50/60Hz
Advantages:
- High cutting capacity
- Quick and secure clamping
- Rugged and compact construction
- Easy handling
Installation & Processing
■ Measure the inside diameters of the pipe to be processed and
choose a suitable machine and expansion block.
■ Select the appropriate block, place it on the bottom of the
expansion block to ensure the top surface of the expansion block
remain horizontal without any inclination, and rotate the sleeve
anticlockwise to tighten the expansion block and, ensure that the
machine is firmly fixed in the pipeline.
■ Choose a tool with suitable angle listed in the tool table based
on the processing requirements, install it on the cutter head of
the machine and tighten the bolts to fix the tools.
■ Rotate the feed hand wheel and extend the feed spindle Loosen
screw and feed.
■ Stretch the machine expansion mechanism into the pipe, and
reserve sufficient feed space between the tool on the cutter head
and the pipe end face.
■ Rotate the expansion sleeve with the ratchet wrench while
adjusting the position of the machine to ensure the feed spindle
and the center of the pipe is concentric; Tighten nuts on the
expansion sleeve with the ratchet wrench after determining the
position.
■ Start the motor. Rotate the feed handwheel to make the cutting
edge contact with the pipe wall, and then bevel.
