ZMP1102B Basic Pneumatic Training Panel Pneumatic Trainer
Mechatronics Training Equipment
1. Structure
Basic pneumatic trainer is designed for “hydraulic and pneumatic
training”, it meets modern pneumatic transmission requirement.
Students can learn basic pneumatic circuit control knowledge, and
practice hand on ability. Pneumatic trainer combines electrical and
mechanical transmission knowledge.
This trainer is suitable for colleges, engineer university,
technical schools, vocational schools, engineer training centers,
factory training department etc.
Through this trainer, students can master pneumatic components
structure, pneumatic circuit control theory, pneumatic circuit
design, and hand on ability for pneumatic trainer.
This trainer is flexible and students can design their own
pneumatic circuit.
2. Introduction
1. Panel type, without workbench, it is easy for transportation.
2. Every pneumatic component is an individual module, it has
quickly plug in and plug out sockets, can put in aluminum panel and
build pneumatic circuit.
3. Use stainless air compressor, running has low noise, it supply
good environment for training.
4. Pneumatic circuit use quickly plug in and plug out leads, it is
suitable for students to build pneumatic circuit. Students can
combine theory to practice, and practice hand on ability.
5.Transparent components structure, it is easy to observe. It is
with beautiful look.
3. Technical parameter
(1) Slot space:25mm
(2) Panel material: aluminum
(3) Dimension 1200*750mm
4. Technical parameter
(1) Slot space:25mm
(2) Panel material: aluminum
(3) Dimension 1200*750mm
5. Basic structure
Pneumatic control experiment workbench including experiment
workbench, experiment shelf, pneumatic components etc.
Pneumatic components and real equipment: air filter, decrease
pressure valve, service unit, hand-operated direction valve,
pneumatic control direction valve, strike valve, check valve,
throttle valve, exhaust valve, single acting cylinder, double
acting cylinder etc.
