ZMP1102 Basic Pneumatic Training Panel Didactic Equipment
I. Structure
Basic pneumatic trainer is designed for “hydraulic and pneumatic
training”, it meets modern pneumatic transmission requirement.
Students can learn basic pneumatic circuit control knowledge, and
practice hand on ability. Pneumatic trainer combines electrical and
mechanical transmission knowledge.
This trainer is suitable for colleges, engineer university,
technical schools, vocational schools, engineer training centers,
factory training department etc.
Through this trainer, students can master pneumatic components
structure, pneumatic circuit control theory, pneumatic circuit
design, and hand on ability for pneumatic trainer.
This trainer is flexible and students can design their own
pneumatic circuit.
II. Introduction
1. Workbench has 4 wheels, it is suitable for move and
installation. 2 wheels can be lockable. It use aluminum panel, the
distance for slot is 25mm, there is quickly plug in and plug out
sockets under components, students can plug components on aluminum
panel easily.
2. Every pneumatic component is an individual module, it has
quickly plug in and plug out sockets, can put in aluminum panel and
build pneumatic circuit.
3. Use stainless air compressor, running has low noise, it supply
good environment for training.
4. Pneumatic circuit use quickly plug in and plug out leads, it is
suitable for students to build pneumatic circuit. Students can
combine theory to practice, and practice hand on ability.
Dimension: 1250mm*350mm*1000mm
