Antenna lightning arrester lightning arrester coaxial lightning
arrester outdoor antenna protection signal
Product Details
The sky feed arrester is installed between the communication
equipment, the coaxial cable joint or the two communication
equipment, which can effectively prevent the transient overvoltage
caused by the lightning induction to the communication equipment.
It is suitable for all kinds of radio frequency transceiver system,
wireless network signal transmitting, satellite TV receiving
equipment, and monitoring signal wireless transmitting and
receiving equipment.
Product features
1. The technology is exquisite, and can work in bad environment for
a long time.
2. resistance to impact and corrosion resistance
3.. Multilevel protection with large circulation capacity.
Product specification.
| Model and specofocation | | TRSW-BNC |
| Frequency range | | DC-1.5 GHz |
| Working voltage | | 500V |
| Nominal discharge current | In(8/20μS) | 10kA |
| Insulation resistance | | ≥5000 MΩ |
| Dielectric withstanding voltage | | 1500V |
| Impedance | | 75Ω |
| Interface mode | | BNC.N.UHF.TNC and so on |
| Operating condition | | Temp:-40℃~+70℃ |
| | RH≤95%(25℃) |
| | Sea level elevation≤3km |
| Remarks | | Other max continuous operating voltage can be customized |
Working principle of product
The lightning protection device is based on the principle of
standing wave antenna and lightning wave spectrum design. The main
part is a short rod equivalent to the end of the 1/4 wavelength.
When the signal is sent out, a part of the impedance is reflected
back because the impedance is not fully matched, and the wave will
form a standing wave when the wave is superimposed on the incident
wave originally emitted. The amplitude of standing wave at each
point of the line is fixed first. For the transmission line with
terminal short circuit, the terminal is short circuited, so the
current is large and the voltage is small. For the signal end, the
voltage and the current are small.
That is, the most close to the open circuit of the signal terminal
impedance, so the loss is small, but for the lightning wave because
of its wide spectrum range, and most of the energy is concentrated
in the frequency band below 10HZ, so the short circuit rod is short
circuited to the lightning, and will not invade the equipment to
cause damage.
Use of attention
1. lightning arrester should be connected to the feeder line and
installed near the protected equipment.
2. when the system fails to doubt the lightning arrester, the
lightning arrester can be dismantled and rechecked. If the system
is restored to normal after it is restored to the state before use,
the lightning arrester has been damaged and must be replaced
immediately.
3. please recognize the interface and connection mode.
Company profile
Zhejiang Thor Electric Co., Ltd is committed to meeting the
requirements of the European Union’s Waste Electrical and
Electronic Equipment (WEEE) directive. This directive requires
producers of electrical and electronic equipment to finance the
take-back for re-use or recycling of their products placed on the
EU market after 2005.
Product packaging:Carton packing
Transportation method
1. Express company: FEDEX,UPS,DHL,TNT
2. Trains, ships, aircraft transport
