Home control signal network, signal protection, lightning
protection, two in one, automatic signal surge protection
Brief introduction
The control signal network lightning protection and two in one
protector is mainly used for lightning protection measures against
network system and control signal, and is an important
manifestation of internal lightning protection. It can protect
equipment from such products as inductive lightning current, surge
voltage, electrostatic interference, radiation interference and
internal overvoltage. It has many advantages, such as large
discharge current, low voltage limit, high reliability and long
service life.
Product features
1. transmission distance can be transmitted by a long distance of
100m!
2. self protection voltage is more than self protection, automatic
disconnection and recovery.
3. metal shielding layer, to prevent electromagnetic interference,
so that the signal is more stable.
4. advanced production process and beautiful appearance
Use of attention
1. lightning protector should match the working voltage of the
protected equipment. Please install according to the installation
sketch.
2. lightning protection device IN as input and OUT as output, the
input end is connected with the outside, and the output end of the
input end of the connecting device is protected.
3. The PE line of the lightning arrester must be reliably connected
to the ground wire of the lightning protection system, and the
connection line is short, thick and straight.
4. lightning protector should be regularly tested during operation.
If there is any failure, it should be maintained or replaced in
time to ensure equipment safety.
Product specification
| Type | TRSS-RJ45 |
| Max continuous operating voltage Uc(VAC) | 5V |
| Nominal discharge current (8/20μS) ln(kA) | 5kA |
| Voltage protection level Up(kV)≤ | 20V |
| Adaptive date transfer rate | 100/1000Mbps |
| Insertion loss | ≤1dB |
| Respeonse Time | ≤1ns |
| Protect network lines | 1~8 |
| Surface Properties | 100x25x25 |
| Line interface | RJ45 |
| Way to lnstall | Series Connection |
Working principle of product
During the operation of the equipment, the lightning arrester will
play a protective role once the abnormal voltage occurs. When the
protected device is running under normal working voltage, the
arrester will not work, and it will be regarded as a circuit for
the ground. Once the high voltage is present and the insulation of
the protected equipment is endangered, the lightning arrester acts
immediately and leads the high voltage impact current to the earth,
thus limiting the amplitude of the voltage and protecting the
insulation of the electrical equipment. When the overvoltage is
gone, the arrester is restored to its original state quickly, so
that the system can supply electricity normally. The main function
of the lightning arrester is to reduce the voltage value of the
protected equipment through the action of parallel discharge gap or
nonlinear resistance, and to reduce the voltage value of the
protected equipment, so as to protect the power equipment.
Company profile
Thor is all about protecting against the damaging effects of power
transients. It is our goal and mission to connect our customer
challenges with high-quality, right-priced solutions and products –
completed by unrivaled customer service and technical support.
Incorporated in 2006, Zhejiang Thor Electric Co., Ltd has built
everything to offer a wide range of innovative and reliable surge
protection solutions and products.
