IEC 62368-1 Annex G15.2.3 High And Low Temperature Tensile Testing
Equipment Test Force 500kg
Product overview:
This machine is controlled by computer and is widely used in
mechanical performance tests of non-metallic materials such as
rubber, plastics, wires and cables, textiles, waterproof materials,
non-woven fabrics, metal wires, metal foils, metal plates and metal
rods. It can also be used with special fixtures. It is suitable for
tensile, compression, peeling, shearing, tearing, bending (folding)
tests of various finished products. It can print multiple data, and
can make graphic output comparison according to different data,
with high control precision and easy operation; it adopts modular
design, and various accessories are complete in variety and
flexible in matching.
This tensile testing machine is required by IEC 60227-1 Clause
6.2.4 Table 1, IEC 60245-1 Clause 6.2.4 Table 1, IEC 60811-501, IEC
62930 Table 3, IEC 62368-1 Annex G15.2.3, etc.
Control software introduction:
1. Software operating system language: English and Chinese.
2. Force unit: N, KN, Kgf, Lbf
3. Length unit: mm, cm, inch can be freely converted
4. Control mode: speed, load breaking (breaking), running time and
other control modes can be set through computer software.
5. Types of curves: load-displacement, load-time,
displacement-time, stress-strain, strain-time, stress-time. The
vertical and horizontal coordinates of the curve can be set
arbitrarily.
Technical parameters:
Test Force Range: 0–500kg
Unit Switch: Kg, N, Lb (freely switchable)
Load Resolution: 1/250,000
Load Accuracy: ±0.5%
Displacement Switch: mm, cm, in
Force Measurement Display Accuracy: 0.001Kg
Displacement Measurement Display Accuracy: 0.001mm
Deformation measuring device: large deformation measuring device
Deformation measurement range: 0.2%—100%FS
Test Stroke: 800mm (including fixture)
Effective Test Width: 400mm
Speed Test Range: 0.05–500mm/min, stepless speed regulation
Drive System: Uses servo motor, Taiwan Hiwin ball screw, and TM2101
software
Safety Features: Overload emergency stop, upper and lower stroke
limit devices, automatic stop function at breakpoints
Test Fixture: Customized fixture based on product
Working Power Supply: AC220V 50Hz
Working Power: 1.0KW
Total Weight: Approximately 600kg
High and Low Temperature Test Chamber Parameters
| Volume | 128L |
| Inner box dimensions (width, height, depth) | 400 ×800 × 400mm |
| Outer box dimensions (width, height, depth) | Customized |
| Machine weight | About 300kg |
| Temperature range | -40℃~+150℃ |
| Control stability | ±0.5℃ |
| Distribution uniformity | ±2.0℃ |
| Heating rate | 3℃/min non-linear no-load |
| Cooling rate | 1℃/min non-linear no-load |
| Using Power | AC220V, 50HZ |
