4W 1.7GHz 8CH Ultra Light FPV VTX 25.85g Low Latency for Racing
Drone
I. Product Appearance
II. Product Dimension
III. Specifications
1 1.7GHz 8CH: 1680MHz-1960MHz
2. Max power: 4W (25mW/2000mW/4000mW, adjustable)
3. Input voltage: DC 7V-36V, supporting 2-8S battery input
4. Antenna connector: SMA Mother seat inner hole
5. Smart audio: IRC Tramp
6. Heat-dissipating method: aluminum alloy shell, heat sink&fan
7. Hole spacing: 20mm*20mm/ø2mm
8. Dimension: 53mm*28.85mm*16mm
9. Weight: 25.85g.
IV. Function Introduction
1. Channel indicator: Red LED
2. Band indicator: Blue LED
3. Power indicator: Green LED
4. Band & Channel changer button
5. Power changer button
6. 1.0 6P Power connector
V. Control Method and LED Indicator
1. Button 4 is used to switch band and channel; every time when
button 4 is pressed for a short time to switch to the next channel,
the red LED 1 will flash, 1.2.3.4.5.6.7.8 in turn. The operation
can be cyclic; see the following diagram for details!
2.Button 5 is the power adjustment button. Each short press
switches the power by one level, cycling through the four levels of
25mW, 2000mW, and 4000mW. The green LED is the power indicator
light, with the following states as shown in the figure below: 25mW
flashes once, 1000mW flashes twice, 2000mW flashes three times, and
4000mW flashes four times. Press and hold for 3 seconds to enter
pit mode, with the green light staying on. See the figure below for
details!
Note: This image transmission device has a temperature protection
function. When the temperature of the image transmission device
exceeds 100°C, the transmission power of the image transmission
device will be reduced by one level. If the temperature remains
above 100°C, the transmission power will be reduced by another
level until it reaches the lowest power level (25mW). At this
point, the temperature of the image transmission device will
decrease. When the temperature drops to 95°C, the transmission
power will return to the originally set power level.
VI. Frequency Table
VII. Illustrate of 6P 1.0 Wiring
Wiring Table:
VIII. Notice for Use:
1. The VTX must be installed with space to ensure that the air
convection around the module to ensure that the module heat
dissipation; otherwise, the module overheating protection start,
reduce the power to transmit, or even shut down the power to
transmit.
2. It is recommended that before turning on the power, to ensure
that the correct voltage range, positive and negative poles are
correct, so as not to burn components.
3. It is recommended that before turning on the power, make sure
that the RF RF output has been installed antenna, which can extend
the life of the module.
4. Please read the instruction manual before use, so that you can
correctly wire and extend the module service life.
