5W 1.2G Wireless Video Transmitter 1.2Ghz VTX Remote Transmission
Drone Accessories Image Transmission
I. Product Appearance
II. Product Dimension
III. Specifications
1. 9CH 1.2G frequency range: (1080MHz-1360MHz);
2. Max power: 5W (25mW/5000mW, two level adjustable);
3. Input voltage: DC 7V-36V, supporting 2-8S battery input
4. Antenna connector: MCX
5. Smart audio: IRC Tramp
6. Heat-dissipating method: aluminum alloy shell, heat sink&fan
7. Hole spacing: 30.5mm*30.5mm /ø3.0mm
8. Dimension: 38mm*38mm*20.7mm
9. Weight: 38g
IV. Function Introduction
1. Channel indicator: Red LED
2. Band indicator: Blue LED
3. Power indicator: Green LED
4. Band & Channel changer button
5. Power changer button
6. 1.0 6P Power connector
7. Cooling Fan Power Cable Holder
8. MCX antenna connector
V. Control method and LED indicator
1. Button 4is used to switch band and channel; every time when
button 4 is pressed for a short time to switch to the next channel, the red
LED 1 will flash, 1.2.3.4.5.6.7.8.9 in turn. The operation can be cyclic;
see the following diagram for details!
2. Button 5is the power adjustment button, each short press switches the power
by one step, cycling between the two steps of 25mW and 5000mW. The
green LED is the power indicator, the status is shown in the following figure, 25mW
blinks once, 5000mW blinks twice. Press and hold for 3 seconds to enter pit
mode, the green light is always on. See the figure below for details!
Note: This VTX has a temperature protection function, when the
temperature of the microphone is higher than 100 ℃, the transmitter power of this microphone will be reduced by one
step, if the temperature is still higher than 100 ℃ continue to reduce the power by one step until the lowest power (25mW); at this time, the microphone temperature
will be lowered, and when the temperature is lowered to 95 ℃, the transmitter power will be returned to the originally set power
level.
VI. Frequency Table
VII. Illustrate of 6P 1.0 Wiring
VIII. Notice for Use:
1. The VTX must be installed with space to ensure that the air
convection around the module to ensure that the module heat dissipation;otherwise, the
module overheating protection start, reduce the power to transmit, or even shut down
the power to transmit.
2. It is recommended that before turning on the power, to ensure
that the correct voltage range, positive and negative poles are correct, so as not to burn
components.
3. It is recommended that before turning on the power, make sure
that the RF RF output has been installed antenna, which can extend the life of the
module.
4. Please read the instruction manual before use, so that you can
correctly wire and extend the module service life.
