IEC 60335-2-6 Low Carbon Steel Vessel For Hotplates Test Cooking
Appliance
Standards For Low Carbon Steel Vessel For Hotplates Test:
The vessel conforms to the standard requirements of IEC
60335-2-6:2018 clause 3.1.9.101 figure 102, IEC60335-2-9:2016
clause 3.1.9.108 figure 104, CISPR 14-1:2016, and etc.
Application For Low Carbon Steel Vessel For Hotplates Test:
The vessel simulates the cooking appliance which is placed on the
induction hotplate. The vessel is made of low carbon steel having a
maximum carbon
content of 0.08%.
Technical Parameters For Low Carbon Steel Vessel For Hotplates
Test:
| Material | Low carbon steel having a maximum carbon content of 0.08% |
| Dimensions(mm) | dh(height)δ(base thickness)=Ф300×100×(5±0.5) |
| Wall Thickness(mm) | 2±0.5 |
| Maximum Concavity (mm) | C≦0.006d, not to be convex |
| Shape & Configuration | Without metallic handles and protrusions, without cover, cylinder |
The dimensions and shapes are manufactured according following
figure and table:
Test Procedures and Operation For Low Carbon Steel Vessel For
Hotplates Test:
Please refer to the relevant standards.
Take IEC60335-2-9:2016 clause 3.1.9.108 as an example:
Induction hot plates are operated with vessels containing cooking
oil. Controls are adjusted to their highest setting until the oil
temperature reaches 180℃±4℃, and are then adjusted so that this
temperature is maintained. The oil temperature is measured 1 cm
above the centre of the bottom of the vessel. For appliances which
cannot heat the oil to 180℃±4℃, the control is maintained at its
highest setting.
Notice For For Low Carbon Steel Vessel For Hotplates Test:
1. The vessel is used to boil cooking oil, please don’t use it to
boil other liquid or medium.
2. After each use, please use clean cloth to wipe it clean.
3. Please do not dry burn the vessel, or the coating of the vessel
will be destroyed, and the vessel will be rusted easily without the
protection coating.
4. Please do not damage the appliance shape and coating (such as
scratching, dropping, etc.).
5. Prevented from dust and moisture environment, in order to avoid
the rusts.
