14.5mm Hole Diameter 0543 System 13 30mm Solenoid Magnet Valve
Coil
The electronic drain valve is a combination of a solenoid coil, a
timer, a solenoid valve and a filter tennis valve. The timer
adjusts the valve opening interval and discharge time. The
principle of the electronic drain valve is: the solenoid valve coil
controls the opening and closing of the valve, and the time and
period of automatic drain opening can be adjusted by setting the
upper switch. The automatic drain valve is suitable for use in
compressed air storage tanks or other gas pressure vessels to
remove water or hazardous liquids. The automatic drain valve is
mainly composed of a valve body, a valve cover, a valve core, a
spring, an adjusting bolt, a drain hole, a valve body through hole
and the like, and has a simple structure, is easy to manufacture,
has a small volume, and is convenient to use. Drainage or other
harmful liquids can be used to replace the sewage shut-off valve in
the lower part of the gas storage tank at the lower part of the
compressor air reservoir. Guarantee gas quality and prevent
corrosion of pneumatic tools and piping components.
Technical parameter of electronic drain valve solenoid coils:
| Model No. | BB14542004 |
| Normal voltage | DC12V/DC24V/AC110V/AC220V; or OEM |
| Normal power | AC:22VA; DC:13W 20W |
| Insulation class | H |
| Connection type | DIN43650A |
| Application | Electronic drain solenoid valves accessories coils |
| Weight | 160.5 g |
| Hole size | 14 mm |
| Height | 42 mm |
| Width | 29 mm |
Main dimension of 5043/5045 solenoid coils for water electronic
drain valve:
Detail enlargement of 14 mm Inside Hole 42 High electric solenoid
coils:
Connection of AC220V/DC24V black electromagnetic coils in
electronic drain valve:
In the process of using the electronic drain valve, the following
points should be noted:
1. Before installing the drain valve, it is preferred to remove the
sludge, copper scrap, rust, etc. from the compressed air system. It
is recommended to drain the system for 3-5 minutes under full
pressure before installing the drain valve.
2. The direction of drainage is the same as the direction of the
arrow on the valve body.
3. The supply voltage should be consistent with the drain valve
voltage (the drain valve voltage is marked on the coil). Do not
connect the wrong power supply.
4. The test membrane switch on the timer is a manual test button.
Each time the button is pressed, the drain valve is discharged
once. This button is used to check the drainage condition at any
time in daily work.
5. The two knobs of the timer are used to adjust the discharge and
interval time. The user should adjust the time according to the
climate and working conditions.
6. In addition to the connection function, the small screws on the
drain valve junction box have the function of pressing the seal to
prevent water from entering the timer and the coil, so be sure to
tighten. Otherwise, the gasket will not be waterproof, which will
cause the coil. And the burning of the timer. The lock nut of the
terminal is also waterproof, so be sure to tighten.
7. When the electronic drain valve is in use, the solenoid valve
may not be tightly closed, which is always leaking. Usually the
fault is not caused by the quality of the drain valve itself. The
reason is that the condensate is too dirty, and the tiny solid
particles in it Enter the valve plug and catch the valve plug.
Welcome to your inquiry!
