12ga ,10ga Insulation Mini Cupped Head Weld Pins For Hvac System
Details of Insulation Mini Cupped Head Weld Pins:
1. Certification: ISO9001
2.Material: Low Carbon Steel, material specifications or certification
available.
3.Finish: Mild Steel pins are galvanized/coated, washer is galvanized.
4.Annealing: All steel pins are fully annealed unless otherwise
specified.
5.Paper Insulating Washers:Available for welding through foil faced insulation.Paper
insulating washers
canbe ordered separately or factory installed.
6.Compatibity: All pins are compatible and recommended for use with CD stud
welding equipment
Cupped Head weld Pins simplify the permanent installation of "Duct
Liner" or other insulation materials
to duct work or to other heating, ventilating or air conditioning
sheet metal configurations and housings.
A fabricated part made by weld pin and a staked on retaining
washer.Variations of material are available.
This product is usually applied with a capacitor discharge stud
welder. Used for securing insulation.
Pic of Insulation Mini Cupped Head Weld Pins:
Specification of Insulation Mini Cupped Head Weld Pins:
| common size of Insulation Mini Cupped Head Weld Pins: |
| Cupped Head Weld Pin diameter | base size | length |
| 2.7mm | 25mm, 30mm | 15-250mm |
| 3mm | 25mm, 30mm | 15-250mm |
| 3.4mm | 25mm, 30mm | 15-250mm |
| the material can be made with stainless steel ,mild steel |
Standard of Insulation Mini Cupped Head Weld Pins:
| 12ga ,10ga Insulation Mini Cupped Head Weld Pins For Hvac System | Standard of materials |
Low Carbon Mild Steel 4.8 (weldable)
Stainless Steel A2-50 (weldable)
Aluminium Alloy AlMg3
Pure Aluminium
Lead Free Brass 4.8 (weldable) | EN 20898-1
EN ISO 3506-3
EN 573-3 EN 573-3
ISO 426 –1 / ISO 1638 |
Install of Insulation Mini Cupped Head Weld Pins:
Each PowerPoint Weld Pin is precisely formed to provide optimum
electrical resistance and each cap
and shank assembly is securely swaged so that pins ill feed without
jamming, even in older welders.
The result is continuous production without the expense of clearing
track jams or refastening where
other pins could fail.
Recommended assembly method:
1.Work surfaces should be clean and dry, free of dust, grease, oil
and any other loose matter.
2.Remove the protective release paper taking care not to touch the
adhesive.
3.Place the hanger in the required position and press the base
against the surface to be insulated
4.Insulation can be impaled immediately and firmly locked with
fastening clips but maximum strength of
adherence is achieved after 24 hours
Package of Insulation Mini Cupped Head Weld Pins:
Package : usually the package is 800/1000/1500 /2000/3000/5000 pcs
in carton on pallet
800/1000/15000/2000 in a drum on the pallet
Delivery :for big you choose by sea
for small order or agercy order ,you can choose express by
DHL,Fedex ,UPS ,ect
we can also supply door to door service by sea ,by air
