Digital Torque Tester For Lamp Holders With High-Precision LCD
Display
Product information:
Torsion resistance is as a safety requirement index for the
mechanical strength of lamp holders for light sources, has been
valued by manufacturers of lamp caps for various light sources.This
lamp caps torsion resistance meter for light sources meets the
anti-torque measurement requirements of various quality inspection
agencies and manufacturers for LED bulbs, energy-saving lamps,
incandescent lamps, straight-tube fluorescent lamps, high-pressure
mercury lamps, sodium lamps and other light sources.
This device can be equipped with fixtures for lamp caps of E27,
B22d, E14, B15.
With different fixtures, this equipment can test the torsion
between the lamp holder and the plastic part, the plastic part and
the plastic part cover, and the plastic and the lamp caps.
Features:
● Using 5-inch high-definition LCD touch screen display, the
appearance is novel, and the parameters are clear at a glance;
● The lamp caps is fixed with a fixture, and the positive and
negative torque of the lamp caps can be measured by directly
rotating the light source;
● Torque test range: 0~10N.m (special range can be customized);
● The test is convenient, and the special lamp caps fixture can be
customized;
● Using strain gauge torque sensor, high reliability, high
precision and long life, with maximum torque value retention
function, upper limit alarm can be set;
● Comply with international and domestic standard requirements.
Technical parameters:
1. Measuring range:0—10N·m
2. Measuring accuracy: ≤1%
3. Repeatability: ≤0.5% FS
4. Linear: ≤0.5% FS
5. Hysteresis: ≤0.5% FS
6. Overload capacity: 120% FS
7. Temperature compensation range:-10℃—60℃
8. Rated operating conditions: temperature:25±5℃, humidity:≤65%R.H,
power supply:Two-phase: 220 V (phase-to-phase), 60 Hz.
9. Allowable working conditions: Temperature: 0-40℃,
humidity:≤75%R.H, power supply:Two-phase: 220 V (phase-to-phase),
60 Hz.
10. Dimensions:W×H×L (330mm×110mm×335mm)
11. Power consumption:15VA
12. Should work with following torque test gauges (note: the test gauges should be prepared by user, not included in
this machine):
E14 | IEC62560 Figure 3 |
E27 | IEC62560 Figure 3 |
B15 | IEC62560 Figure 4 |
B22 | IEC62560 Figure 4 |
