IEC 60068-2-32 Procedure 1 Free Fall Test Machine For Impact
Resistance For Packaging Falling
Product information:
Standard: IEC 60335-1 Annex B, IEC 60068-2-32 procedure 1, ISTA,
GBT 21599-208, ISO2248, JISZ0202-87, GB/T4857.5-92, etc.
This machine is specially used to test the damage of product
packaging caused by falling, and to evaluate the impact resistance
during transportation and handling. It can perform free drop tests
on the surfaces, corners and edges of packages, and is equipped
with a digital height display and a decoder for height tracking. As
a result, the drop height of the product can be accurately given,
and the error from the preset drop height will not exceed 2% or
10mm.
This machine adopts a single-column structure and has electric
reset, electronically controlled drop and electric lifting devices,
making it easy to use. The drop height is accurate, the display is
intuitive, the drop arm rises and falls smoothly, and the drop
angle error is small.
Technical Parameters:
1. Model: Detachable
2. Drop height: 300-1500mm, adjustable
3. Maximum weight measured: 0-65kg
4. Maximum size of test piece: 800 × 800 × 800mm
5. Impact panel size: 1700 × 1200 × 25 (solid iron plate, thickness
25mm)
6. Support arm size: 160 × 180 × 8mm
7. Drop error: <2°
8. Drop height error: ±10mm
9. Control box size: 370 × 350 × 910mm
10. Overall dimensions of the test bench: approximately 1700 × 1200
× 2300mm
11. Equipment weight: about 550kg
12. Power supply: AC220V 50HZ (please confirm the power supply used
on site. If you need to change to other voltages, please note the
quotation in advance)
13. Power: 1.5KW
Environmental requirements:
1. On-site temperature: 5℃~+28℃ (average temperature within 24
hours ≤28℃);
2. Relative humidity: ≤85%RH;
3. Power supply conditions: single-phase three-wire;
4. Voltage range: AC220V;
5. Allowable frequency fluctuation range: (50±0.5) Hz;
6. The grounding resistance of the protective ground wire is less
than 4Ω;
7. The user is required to configure an air or power switch of
corresponding capacity for the equipment at the installation site,
and this switch must be independent for use by the equipment.
